Hello,

I am working on replacing a Micrologix 1200 (that was talking through a Digi One IAP serial to ethernet converter) with a Micrologix 1100 that talks Ethernet natively.

I have a SLC500 that is attempting to do a Read via a MSG block with these settings but I am getting no data:
Capture.jpg

I can communicate fine with the 1100 and I see data constantly changing in both N10:0 and N10:1. The SLC MSG block gives me "Connection not completed before user-specified timeout".

Do I have to change the MSG config to MultiHop: Yes and enter the IP in that tab for this to work? I have other MicroLogix 1100's communicating fine and this is the only difference I can find in the configs.

Thanks,
Kris